Guide for band saw blades exploitation

Band Saw blades are shaped strips with toothed edges. Band Saw blade dimensions and production characteristics depend on sawmill. Whereas a band saw blade is a tool blade with large, complex requests that are generated during work, we recommend extreme caution in its use and maintenance.

Band saws blade mounting is done by placing it on the two flywheels and by moving vertically up the two camps of upper flywheel.

The flywheel is adjusted so that the bottom blade tooth is at a distance of 3-5 mm from the flywheel.

Stretching blade force is 160N/mm2, depending on the blade width and chart out the Saw.

For proper operation of sawmill, flywheels and band saw blade must stay clean of sawdust, resin and other impurities. Flywheels are maintained clean by brass scrapers and felts that ensure anointing with diesel. Cleaning band saw blade is made using felt boards fixed to tanks with diesel coming in contact with the blade. All these devices are checked and cleaned before every blade replacement. Also check the diesel fuel in the tank.

The teeth side of the blade is led by one or two guides that reduces the free length of the blade, thus increasing its stability. Guides surface that comes in contact with the canvas should be checked once a day and must be perfectly flat, otherwise it should be replaced with a new or corrected one.

Since the operation of band saw blade coefficient of utilization of working time is small, the blade idling an important time versus working time itself and therefore it gets tired without carrying out useful work, the maximum working time of a wire is four (4) hours. The minimum rest period is at least twice the recommended cutting time but a resting time of twenty (20) hours is recommended.